M106 P0 S0 I0 F500 H1:2 T200 set fan 0 value, PWM signal inversion and frequency. M106 P0 S0 I0 F500 H-1 set fan 0 value, PWM signal inversion and frequency. M143 H2 S120 set temperature limit for heater 2 to 120C M141 H2 assign chamber heater to heater 2 – Removed to set Chamber heater in S3D M563 H2 P5 S”Chamber Heater” Set Tool 5 to set Chamber heater in S3D M570 H1 P4 T25 Allow 25C varation from setpoint M143 H1 S480 set temperature limit for heater 1 to 480C M143 H0 S280 set temperature limit for heater 0 to 280C G31 P500 X-52 Y-8 Z0.45 set Z probe trigger value, offset and trigger height M558 P5 H5 F120 T6000 I1 set Z probe type to effector and the dive height + speeds M574 Z1 S2 set endstops controlled by probe M906 X1500 Y1500 Z800 E800 I30 set motor currents (mA) and motor idle factor in per cent M350 X16 Y16 Z16 E16 I0 configure microstepping with interpolation M569 P3 S0 physical drive 3 goes backwards M569 P2 S1 physical drive 2 goes backwards 0 M569 P1 S1 physical drive 1 goes forwards 1 M569 P0 S1 physical drive 0 goes forwards 1 M555 P2 Set firmware compatibility to look like Marlin generated by RepRapFirmware Configuration Tool v3.1.3 on Fri 20:17:53 GMT-0700 (Pacific Daylight Time) Configuration file for Duet WiFi (firmware version 2.03) My config.g is based on the one you provided with some changes. It is this behavior expected with the 500C extruder ? I attached my config.g file below in case its a configuration issue. The bed heater and the chamber heaters are working perfectly. With the chamber heated up it appears to stabilize once it reaches around 110C. I noticed at room temperature the extruder sensor bounces around a bite.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |